DETAILS INSTRUCTION
Instructions for use
Special instructions before use
Please wear goggles, a mask, and gloves before using this product!
Watch out for splashes
Pay attention to protection
Do not mix with other chemicals
Keep out of reach of children
Please strictly follow the instructions and precautions when using this product;
Add an appropriate amount of clean water (room temperature or warm water is fine) to the pipe. If water has already seeped out of the pipe opening, there is no need to add water; remove any water outside the pipe opening. Then put on your protective gear.
Place one 120g packet of this product into the drain pipe, then flush with 500ml-1L of clean water (for severe blockages, warm water is recommended to significantly enhance the product's dissolving ability); if there is already residual water in the pipe, flush more water as needed depending on the product's reaction.
After waiting 30-60 minutes, flush with plenty of water. If the blockage is severe, repeat the process.
Dosage recommendations
1. For unclogging drainage systems in sinks, vegetable basins, mop sinks, and floor drains (kitchen, shower rooms, etc.), the recommended dosage is about half a bag or one bag (60g-120g).
2. For unclogging toilets and squat toilets, the recommended dosage is approximately 1-2 packets;
3. For main pipe unclogging, use approximately 3 bags. For routine pipe cleaning and maintenance, use 1-2 bags per pipe.
During the use of this product, it is recommended to shut down the drainage system for 30 minutes to 1 hour to allow sufficient time for the product to take effect. Then test the unblocking effect with plenty of water. If it is still not clear, repeat the above steps for best results.